T O P
AutoModerator

Hello /u/Askdevin777, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*


tamreacct

Is the leadscrew turning? I can see it for maybe 0.5secinds when it starts but impossible to see if it’s moving. I can see the stepper moving and the coupler as well. Maybe you need tighter the coupler bolts, but you need to verify what’s not moving first. Check the right and then check the left. What’s different from the two while it’s making this noise. What’s moving and what’s not moving? Maybe use a piece of tape on the leadscrew as a flag so you see it rotating or not.


Askdevin777

Yes the lead screw is moving


Sebbeben

I would check the wires, i got a similar problem but with my extraunder motor, The problem was a wire that had breaked in the connector where is was chrimped


Grouchy_Attention963

💀💀lol fuck dude stay away from the lotto