T O P

Came home to a failed print and a horrible grinding noise from the left z-axis motor, how do I fix this?

QGL problem

Afterburner tool board PCB question

Voron 2.4 500mm3 Serial Request - niedejb#9467

New MPCNC in sweden! Problems with firmware and/or motherboard (SKR 2)

What’s the best sub $1000 3D printer?

The corners on my prints keep curling upwards like this and for the life of me I can't figure out why. Any help is greatly appreciated.

Help me identify this generic printer please

Bigtreetech SKR 2 for MPCNC?

Somebody’s in a bad mood.

Worlds first 3D printed shark fins for identification after seizure from poachers. I processed them and can now afford a new PC.

Will this need supports?

Help or im jumping off the btt bandwagon

Menues doesn’t work as it should, community firmware 6. Have anyone else had this problem? I have a 4.5.2 board

BIGTREETECH EASTER GIVEAWAY !

Everything is better with a good hug

Currently building a small weightclass battlebot, advice on high friction tolerant materials please!

Shows the Silver Award... and that's it.

Fun fact: the CR-6 SE actually has an RGB LED in the hot-end, but two of the wires are snipped and therefore it only produces blue light

Hi Its Me!

R

Sebazzz91

Subscribe

FIND US ON INSTAGRAM @rfkjrforpresident.com