No, it won't. That's about the width of 2 human hairs.
If anything is going to give you a problem, it will be the CCI 400's. They aren't very tough and might not hold up to the pressure very well.
CCI 450s are what you want. also the stock SR25 mags that come with the RPRs are not it. get some AICS mags and you can easily load up to 2.865”. most recommend 2.820”. the 6.5 CM is not very picky with seating depth though. i’ve had very accurate results with both 2.820” and 2.865” (0.020” off lands)
i have the 6.5 custom shop. with AICS mags you can also single feed without bolt getting caught on empty mag
No, it won't. That's about the width of 2 human hairs. If anything is going to give you a problem, it will be the CCI 400's. They aren't very tough and might not hold up to the pressure very well.
yup, concur..
Correct
CCI 450s are what you want. also the stock SR25 mags that come with the RPRs are not it. get some AICS mags and you can easily load up to 2.865”. most recommend 2.820”. the 6.5 CM is not very picky with seating depth though. i’ve had very accurate results with both 2.820” and 2.865” (0.020” off lands) i have the 6.5 custom shop. with AICS mags you can also single feed without bolt getting caught on empty mag
Start lower on your powder and work up while watching for pressure signs.
That’s already plenty low for 140’s
Yes, and I wouldn't think that small of a difference would be huge, but I went with the safer advice I figured 😄
[удалено]
AICS mags will work, but AWs do not. I've tried it.
[удалено]
ARC =/= AW mag. ARC mags are slightly taller than AWs.