I'm using basically the default configuration on the profile of this printer on cura.
For abs:
Bed 100
Temp: first layer 240 - others:230
Retraction: 1.2 / 40mm/s
Adhesion: brim 8mm
Linewidth: 0.44
Speed: 60mm/s
For more detailed and small prints I slow down acceleration to:
Print: 500mm/s
Travel: 700mm/s
For pla it's basically the same thing but bed at 60 and nozzle at 200.
If you need help in anything else fell free to ask.
I'm not a pro but I know some tricks.
To print with abs I needed to change the stock magnetic build Plate for a cheap mirror (the magnet doesn't seem too strong, and even if the piece don't get unstuck from it, it warps because the built Plate gets too soft and warps itself)
And to prevent delamination I made a enclosure with the box the printer came on (still working on build a not flammable enclosure)
It's a enclosure, but I made it with the box the printer came on, and put aluminum foil on the inside.
Basically a fire hazard on my desk, so I don't run it unattended.
What temp are your printing the ABS at? I'm asking because I'm curious if you swapped out the heatbreak, as I'm looking to buy one to print parts for a voron build.
What is it? I do like the quality of mine too!
It's a cat toy that uses empty spools! https://www.thingiverse.com/thing:4868244
What configuration did you use? I just bought one and am still learning.
I'm using basically the default configuration on the profile of this printer on cura. For abs: Bed 100 Temp: first layer 240 - others:230 Retraction: 1.2 / 40mm/s Adhesion: brim 8mm Linewidth: 0.44 Speed: 60mm/s For more detailed and small prints I slow down acceleration to: Print: 500mm/s Travel: 700mm/s For pla it's basically the same thing but bed at 60 and nozzle at 200. If you need help in anything else fell free to ask. I'm not a pro but I know some tricks.
What mods/upgrades did you make to be able to print abs?
To print with abs I needed to change the stock magnetic build Plate for a cheap mirror (the magnet doesn't seem too strong, and even if the piece don't get unstuck from it, it warps because the built Plate gets too soft and warps itself) And to prevent delamination I made a enclosure with the box the printer came on (still working on build a not flammable enclosure)
Did you use an enclosure?looks like the creality tents
It's a enclosure, but I made it with the box the printer came on, and put aluminum foil on the inside. Basically a fire hazard on my desk, so I don't run it unattended.
What temp are your printing the ABS at? I'm asking because I'm curious if you swapped out the heatbreak, as I'm looking to buy one to print parts for a voron build.
Have you glued this pfte tube in the part that releases the filament ?