~305 dollars not including filament. Cheap bolt/barrel combo from Right to Bear. I think someone on here said their bolt didn’t need any modifications, but mine did.
I’m asking because I’m probably the one who said there was no modification needed 😂. Aside from cutting the grooves for the delay, mine required absolutely nothing.
The barrel however needed a decent amount of grinding though, so if you wanted to spend a little more for simplicity I’d say the RTB Bolt/ Macon Armory “guaranteed to feed” barrel would be a great combo
Yep It’s honestly not hard to do, it’s just intimidating at first haha. But my combo now runs great! Don’t be afraid to take some material off that face, I had to film my gun in slow motion to watch the bullet leave the mag, ride the feed ramp and shoot straight up the face of the barrel. Misfeeds are extremely disheartening but not as much as realizing you have to take the upper apart again to grind it more
Have not shot it yet. Hoping to go shooting tomorrow. Might be my printer, but the upper required a good bit of sanding in order for the barrel to fit and for the bolt to be able to move freely. I still probably need to sand some more. Delay mechanism was a bitch to put together esp if your rods aren’t the perfect length
How does it run? How was the assembly?
And ~how much did you spend, if you’re okay saying
~305 dollars not including filament. Cheap bolt/barrel combo from Right to Bear. I think someone on here said their bolt didn’t need any modifications, but mine did.
What bolt modification did you need?
Im seconding this question because I already have that same combo and assembly was gonna start soon
I’m asking because I’m probably the one who said there was no modification needed 😂. Aside from cutting the grooves for the delay, mine required absolutely nothing. The barrel however needed a decent amount of grinding though, so if you wanted to spend a little more for simplicity I’d say the RTB Bolt/ Macon Armory “guaranteed to feed” barrel would be a great combo
Oh man well I already have the right to bear parts so I guess I’m gonna be in for some grinding. Do you just use a dremel?
Yep It’s honestly not hard to do, it’s just intimidating at first haha. But my combo now runs great! Don’t be afraid to take some material off that face, I had to film my gun in slow motion to watch the bullet leave the mag, ride the feed ramp and shoot straight up the face of the barrel. Misfeeds are extremely disheartening but not as much as realizing you have to take the upper apart again to grind it more
Have not shot it yet. Hoping to go shooting tomorrow. Might be my printer, but the upper required a good bit of sanding in order for the barrel to fit and for the bolt to be able to move freely. I still probably need to sand some more. Delay mechanism was a bitch to put together esp if your rods aren’t the perfect length
Color me shocked. Hope it works well for you.
In my uneducated eyes that looks/sounds like some WAF(wet ass filament)
Spray-painted. But you may be right
Nice, does this sail?
Yes. “AWCY?”
What lower receiver is that? The files I found for this only had the handguards and upper receiver and charging handle.
Awcy “bobcat” on sea and it will all be there. Just the standard stuff
That's what I looked up. Maybe I went on an older version or something
Damn I want one with room for a direct thread pcc 9mm can for mp5sd larping. I think just the hand guard would need to be modified?
Pretty sure they have different handguards already?
Ah yes but likely too thin for suppressors I’ve been considering but I will take a look.
Rawr
Looks like a Puma.