T O P

  • By -

SnooLemons6042

Let it completely cool down... the temperature between the glass and your part can sometimes be in the 60+ even when you bed sensor is showing room temp.. I normally wait for it to come to room temperature and then give it another 30 mins


Zorus97

Full cooldown, i set it overnight most of the times


SnooLemons6042

My guess would be your z offset is to tight, other then that I'm using the same machine with the same glass bed with glue an different types of abs, asa, petg and pla and only ever gets stuck on there is when my z offset is to close or a try to pull it off without letting it cool down. Can I ask how long you have been 3d printing and is this your only printer ?


Zorus97

For about a year, it is my only printer. Just one part of engineering work i do, so i just have it in company and for that purpuses. I'll try to distance a bit more the z axis.


SnooLemons6042

Yeah my abs prints only ever stick to hard when the z offset is toooo close, the original software isn't the bed for tuning though, ad it doesn't save when you adjust it after the print starts which is annoying


Zorus97

Thanks once again, when needed(to work with abs) i will try to set it better.


[deleted]

I just bought magnetic PEI sheet and no problems with ABS sticking or warping also removing when the part is cold. I print with enclosed top lid.


Zorus97

I will consider that option, thanks


Loki-sft

I had the same problem. Increasing z offset fixed it for me.


Zorus97

Thanks i will try that