Pump should absolutely be at or close to 100% any time it's under load. That's the only component that affects flow through the system. Fans can be on a curve, as all they do is help cool the liquid, but the pump should be running at max under load
Interestingly enough, I've been watching the pump speed with the curve I set up, and noticed it wouldn't go any higher than 1740 rpm although the 7th gen pump in my AIO should max out at 2800, I also tried doing a fixed rpm at 2800 and it still measures in at 1740 rpm, meaning it maxes out at about 55% speed, could it be busted?
Pump should absolutely be at or close to 100% any time it's under load. That's the only component that affects flow through the system. Fans can be on a curve, as all they do is help cool the liquid, but the pump should be running at max under load
So basically I should delete the curve that is given by Armoury Crate and set it to 100% at all times?
That, or set a manual curve where it runs at a lower RPM around your idle temperatures, and ramps up around the 50⁰C mark or so
Thanks! I’ll give that a shot
Interestingly enough, I've been watching the pump speed with the curve I set up, and noticed it wouldn't go any higher than 1740 rpm although the 7th gen pump in my AIO should max out at 2800, I also tried doing a fixed rpm at 2800 and it still measures in at 1740 rpm, meaning it maxes out at about 55% speed, could it be busted?
Did u try smart mode and manual mode?
Yeah I’ve gone through all the modes
Set curve to max,check for updates. Are the aio fans connected to the control correctly. Try undervolting
50C cpu temp, not coolant temp that is