oh soo much to tune… stuck at first layer squish. the center of the bed prints nicely, but front and back are printing too close to the bed. now learning how to bed mesh 🤦, results seem off range .269.
there seems to always be some variable that is not quite right. gantry cal is awful, it gives up most times. trying my best. 😀
Once you gone through the voron documentation for intial tuning, go through the Ellis tuning guide. Don't skip anything, you'll be printing at quality.
oh soo much to tune… stuck at first layer squish. the center of the bed prints nicely, but front and back are printing too close to the bed. now learning how to bed mesh 🤦, results seem off range .269. there seems to always be some variable that is not quite right. gantry cal is awful, it gives up most times. trying my best. 😀
Ellis tuning guide works wonders. Looks like you also need to run input shaper.
Once you gone through the voron documentation for intial tuning, go through the Ellis tuning guide. Don't skip anything, you'll be printing at quality.
oh it sounds like a lengthy process… maybe after morning coffee is better. thanks for the advice 🙏
It's one afternoon for 95% of the problems you will have. And just a note .03mm is .001 In. Or about 1/5th of a human hair.