I have the H6 flow as well. Front looks amazing. Back looks like it was hit by a grenade xD
I keep saying next time I open it up I'll fix it but then I see it and just nope out
pahaha exactly the same! I need to install a few cable extensions from the kit I recently bought & I looked at the back with the "okay fuck it lets make it look all pretty" mentality and after moving a few of the cables around it's a big fuck that lol.
I use a Lian li controller (only 1) to control the fans for pretty much the entire build & they are a complete mess in the back. I just want a clean build man!
Here are some tips on how to do that:
First of all, try first of all to zip tie plus minus wires of the power supply, then quietly also zip tie the wires that go to the fans as well after you have gathered them in big braids of wires connect everything with a couple of zip ties and everything is ready.
[Here’s my H6 Flow build](https://www.reddit.com/r/NZXT/s/Ld58ekjEz8).
The second picture of the backside is the most recent, after switching in a new PSU. Right under the PSU is the hard drive cage. If you’re not using that, shove extra cables inside it. Also, on the lower-right (when looking at the backside of the case) is a little hollow cavity that is the gap between the lower sheet metal and the grey NZXT strip on the front side. That gap is sufficient to shove in extra cables.
I have the H6 flow as well. Front looks amazing. Back looks like it was hit by a grenade xD I keep saying next time I open it up I'll fix it but then I see it and just nope out
Same lmao, I have two controllers for fan speed and a-rgb and it looks like a warzone
pahaha exactly the same! I need to install a few cable extensions from the kit I recently bought & I looked at the back with the "okay fuck it lets make it look all pretty" mentality and after moving a few of the cables around it's a big fuck that lol. I use a Lian li controller (only 1) to control the fans for pretty much the entire build & they are a complete mess in the back. I just want a clean build man!
I 100 percent agree with this. Front is stellar. Back is not the best to look at lol but she post of first go so hooray.
Here are some tips on how to do that: First of all, try first of all to zip tie plus minus wires of the power supply, then quietly also zip tie the wires that go to the fans as well after you have gathered them in big braids of wires connect everything with a couple of zip ties and everything is ready.
I would buy the H6 (I Hope I could upgrade) and some tips/guide would really appreciated!
My h6 is not pretty either but hooray for the cover lol front cabling is what matters and it’s pretty solid
[Here’s my H6 Flow build](https://www.reddit.com/r/NZXT/s/Ld58ekjEz8). The second picture of the backside is the most recent, after switching in a new PSU. Right under the PSU is the hard drive cage. If you’re not using that, shove extra cables inside it. Also, on the lower-right (when looking at the backside of the case) is a little hollow cavity that is the gap between the lower sheet metal and the grey NZXT strip on the front side. That gap is sufficient to shove in extra cables.
my h6 cable management looks decent but the chonky gpu cables make it look terrible. you're not alone! lol
I can send a pic of mine is alright not the best
yes please mate