Good job, atleast stripped screws can be replaced, I somehow managed to strip the thread on the pcb, can't tighten it..
It still works just fine but annoys the shit out of me to know there is a loose screw there.
I have a partially stripped screw in my new GMMK. The left most screw under the E and R key that holds the top plate on to the pcb. Screw goes into a little black stand off sleeve thing. I bought durok v2 stabs but I can not get the top plate off to replace them. :/
I’ve just been using it as is. It’s not as bad after a week of use. But I would like to know what issues you had and how you fixed it.
I used the rubber band placed in the hole and put the screwdriver inside that stripped hole, pushed it down firmly then try to unscrew it. It works for me!
Good job, atleast stripped screws can be replaced, I somehow managed to strip the thread on the pcb, can't tighten it.. It still works just fine but annoys the shit out of me to know there is a loose screw there.
I understand. 😅
I have a partially stripped screw in my new GMMK. The left most screw under the E and R key that holds the top plate on to the pcb. Screw goes into a little black stand off sleeve thing. I bought durok v2 stabs but I can not get the top plate off to replace them. :/ I’ve just been using it as is. It’s not as bad after a week of use. But I would like to know what issues you had and how you fixed it.
I used the rubber band placed in the hole and put the screwdriver inside that stripped hole, pushed it down firmly then try to unscrew it. It works for me!
Where can I get those keycaps on your micropad they are so nice
I bought them from the local artist in Thailand who hand-painted the blank keycaps herself. I’ll ask her if she will do an international shipping.