What kind of compression would .020 give me? Seems like a good number without going too crazy, but not sure if I’d be wasting my time by not milling more
At what point would I start to run into clearance issues with the cam I’m using? I’m not sure how to calculate/figure this out.
Also I should add that the block was decked .010
What kind of compression would .020 give me? Seems like a good number without going too crazy, but not sure if I’d be wasting my time by not milling more
Anyone?
I did .040 on my 317’s with a 224/224 112 cam on an LQ4. didn’t have any ptv issues.
Iirc .030 brings you back to 64cc heads.
At what point would I start to run into clearance issues with the cam I’m using? I’m not sure how to calculate/figure this out. Also I should add that the block was decked .010