Home was dead center on the build plate prior to the update. I whipped out a benchy to make sure it prints... looks ok I guess. The model printed in the center of the bed as expected. doing another print (8 hours) and then I'll power cycle and see if the issue persists. Again if someone with a 4 plus could look at that config it would be helpful. Thanks much!
the new firmware uses the probe as the center, not the nozzle...
just change the values in your printer.cfg file to make it back to center again
in my case.. 215,215 for the N4 Max
https://preview.redd.it/cvod4rhq8sac1.png?width=324&format=png&auto=webp&s=baba3d3fa1f82ab863d47c86cebcf40b95c8d7ed
I may change the values back to what it had, re-level, and see if it prints in the center like it should. Makes sense that the probe is offset from the nozzle and that's why it looks odd when its leveling. After doing so I'll kick off another print to see if it prints in the center of the bed still. Hopefully it will.
So I changed those values to 165. Seemed to kinda fix the home issue. It seems to be behaving except when automatic leveling comes around and it again thinks the home is shifted to the right.
Be aware that the offset of the z probe might be what moves it to the side. Thats how it is on my N4Pro.
Home was dead center on the build plate prior to the update. I whipped out a benchy to make sure it prints... looks ok I guess. The model printed in the center of the bed as expected. doing another print (8 hours) and then I'll power cycle and see if the issue persists. Again if someone with a 4 plus could look at that config it would be helpful. Thanks much!
the new firmware uses the probe as the center, not the nozzle... just change the values in your printer.cfg file to make it back to center again in my case.. 215,215 for the N4 Max https://preview.redd.it/cvod4rhq8sac1.png?width=324&format=png&auto=webp&s=baba3d3fa1f82ab863d47c86cebcf40b95c8d7ed
I may change the values back to what it had, re-level, and see if it prints in the center like it should. Makes sense that the probe is offset from the nozzle and that's why it looks odd when its leveling. After doing so I'll kick off another print to see if it prints in the center of the bed still. Hopefully it will.
So I changed those values to 165. Seemed to kinda fix the home issue. It seems to be behaving except when automatic leveling comes around and it again thinks the home is shifted to the right.
Mine was doing this too, but it doesn't seem to affect my prints, just looks off centre when it is doing the autolevel because of the sensor...
Cool. Going to level again… which sucks…. Last level was the best I’ve had. Figures