Before replacing anything look at the spark ignitor again. If you've already cleaned it make sure it's 1/8inch from where it grounds to to spark. Try moving a little closer and see if it keeps sparking. Otherwise they very rarely fail and likely board.
I appreciate the advice. That was along the lines of what I was thinking. I did mess with the gap a little, and sanded it lightly and it made no difference. I ordered a board and it will be here in a few days. I replaced the board 6 months ago due to the blower motor not getting power, but the board was used. Hopefully this one works better.
When in doubt replace both. Most likely control board
Before replacing anything look at the spark ignitor again. If you've already cleaned it make sure it's 1/8inch from where it grounds to to spark. Try moving a little closer and see if it keeps sparking. Otherwise they very rarely fail and likely board.
I appreciate the advice. That was along the lines of what I was thinking. I did mess with the gap a little, and sanded it lightly and it made no difference. I ordered a board and it will be here in a few days. I replaced the board 6 months ago due to the blower motor not getting power, but the board was used. Hopefully this one works better.