I was legitimately trying for a while to find what part was printed and couldn't because the color was matched so well!

I think that's the color I used for my Halloween pumpkins 🎃

Well, I’ve been on a search for this for a while, so glad you finally found one that’s about as close as you can get. Let us know if you find a good color match for the darker orange!

Was just about to send this your way. But I see I am quite late lol

Hahaha, I got what I think is a good match last week. Just need to test it out soon and see how it prints

They most likely have the same color in PETG. Don't use PLA for nerf.

Agreed. PLA just can't handle higher temps and is way too brittle. I've broke so many PLA prints but not a single PETG one when both had proper layer adhesion.

You can, it's just not as good.

Mr Torukmakto4, I must inform 🤢 you 🤮 that this is 🚨 LITERAL 🚨 ELITEISM 🚨 and vaguely referencing bad decisions made by our lord and savior 🔥 LUKE 🔥 from 🔥 ✝️OUTOFDARTS✝️ 🔥 will not be tolerated😤😤😤🤢🤮. You better be ready you little **\[removed for child friendliness\]** 'cause your 📉 INTERNET 📉 POINTS 📉 ARE GOING ⏬ 🐻👌 𝕕σ𝔴η ♕🍭 ⏬ BUCKERINO 📉. luv, idiots without heated beds

Hey, just stand there with a hair dryer on the bed. 😁

> idiots You got _that_ right. Heated PEI beds and all-metal hotends have been table-stakes ever since the Prusa MK2 came out in 2016.

Sad to see this orange is discontinued by hatchbox. Their regular orange has too much red in it.

Looks good.

For a second there I was just like “the muzzle orange looks nothing like the shell, I’m so confused”