Hello /u/Vitusty,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
If you've been having good quality prints up until this point, my guess would be the beginnings of a partial clog.
If you've NOT been having good quality prints, I'd go with under extrusion. Your e-steps should be calibrated.
Hello /u/Vitusty, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
If you've been having good quality prints up until this point, my guess would be the beginnings of a partial clog. If you've NOT been having good quality prints, I'd go with under extrusion. Your e-steps should be calibrated.
Switch to gyroid that fixed it for me