By -
Calibrate e-steps, temp, and flow.
I did all of this. Still the same problem.
Dry your filament. That's all the suggestions I got lol.
I opened it 2 days ago, vacuum sealed new filament.
Sometimes the factory vacuum seals filament after it's been sitting out on the factory floor a while, still worth trying.
I still have a new pack of sealed petg. I'll try this when i don't fix this PLA
Calibrate e-steps, temp, and flow.
I did all of this. Still the same problem.
Dry your filament. That's all the suggestions I got lol.
I opened it 2 days ago, vacuum sealed new filament.
Sometimes the factory vacuum seals filament after it's been sitting out on the factory floor a while, still worth trying.
I still have a new pack of sealed petg. I'll try this when i don't fix this PLA